Experiment with MMS2 and DMSO

In Jim's book MMS Health Recovery Guide Book page 26

WARNING
● Do not allow DMSO to come into contact with
calcium hypochlorite (MMS2). This will cause
immediate combustion with extreme heat and fire.
In this case, it does not need a spark to start the
fire instantly. Use water to put out such a fire but
stand back as the water will spatter.

I'm wondering anyone tried this chemical reaction?

I poured small amount of DMSO on a small plastic plate, then dropped few MMS2 on it yesterday. Nothing happened, though there might be some reactions to the plastic but I don't see any combustion.

Anyone as curious as me?

I can appreciate that after you saw that warning, you tried it out. Big high five!!!!

wrote:

I can appreciate that after you saw that warning, you tried it out. Big high five!!!!Ye

 

Yes because I'm so scared of dropping MMS2 on the floor or any surface while putting it into the capsules. There are other warnings about MMS2 in the book.

I just want to see if it really starts fire or something like that, though I  did take precaution while experimenting mixing MMS2 with DMSO.

I have done some testing combining MMS2 with DMSO. 

It got very hot along with some smoke seen. 

Did the same testing using HOCL made with an electrolyzer. The combined two ingredients got slightly warm without any smoke seen. 

Following Protocol-2000, separates MMS1 + DMSO dosing from MMS2 dosing by 30 minutes and that seems to be enough time so there is no MMS2 and DMSO heating issue. 

OK I was expecting immediate fire.

I'll try another experiment some time. Thank you.