making mms from flakes

maths is not a strong point and i get headache thinking about numbers.my memory is short term so i get confused. can someone please tell me if i have done it right. i used 200g flakes in .half liter distilled water to make mms thank you

Jeff, that is correct. The simple way to figure is the weight of the SC times 2.57 equals the amount of water (weight). So, you have 200 g of flakes times 2.57 equals 514 g of water. Half a liter of water weighs 500 g, so you are close enough.

Hi Rev.Paul. i have morgellons for 5months now. I've been doing salt/vitamin c protocol and was able to get rid of some of crippling symptoms. Though i still have a few symptoms of morgellons I'm able to function well.
My question to you is can i eat while doing mms protocol? I'm planning to start on 1000 protocol. With this protocol, i will do mms every hour but not sure if I'm allowed to eat or how many hours apart can i eat while doing mms? I still have a few small amounts of mercury fillings on my teeth. Is it safe to do mms despite mercury fillings? I'd like to remove the mercury fillings but it's very costly so i can't do that right now.
Thanks kindly
hope83

Thank you for responding. Do i need to take special precautions when brushing teeth with mms or cds? I'm hahappy to hear that mms and cds will losen mercury. But doesn't the fumes of mercury that get released while brushing is toxic for you to breathe in?
Kindly,
Hope 83

hope83, I and many others brush our teeth using MMS1, CDS and CDH and I have not nor have I read that others have had any problems with our amalgam fillings. I prefer to use CDS as it may be the best for teeth brushing because it contains only CLO2 and water.

after some days new made mms from flakes leaves a precipitate of salt-sand at bottle bottom. I decant whitout disturbing the settled matter and this "dirty" rest is used for cleaning & co.

thank you to all, i have been very poorly with chest and aches and pains not wanted to get up so sorry for delay in getting back to ev1. i have used the 2.57 formula which should be ready tomorrow, and is there a way to check what the ppm would be

thanx

Jeff, you can check your new MMS by making a 3 drop dose of MMS1 and look for yellow color changing to a dark amber color at 30 seconds.

You could also make some CDH or CDS and measure the ppm to see if you get what you got with your older MMS using the same amount of ingredients.